I am replacing the wheel bearing on a 2013 Jetta 2.0L. Are the sizes of the sockets, tools, etc. the same for this model as for earlier models (so 2005-14ish?)? Any do's and don'ts or suggestions before I get started? Any advice would be appreciated.
Wheel Bearing on 2013 Jetta 2.0L
1 - 2 of 2 Posts
Joined
·
9,230 Posts
First posts normally go in introductions else you could get a free fix and we never see you again!!!
Forum Rules and Guidelines
This is a new forum layout with loads of bugs which have been reported in the new thread. There is no TDI Wiki at the moment or original similes. It doesn't show the car spec/location or signature properly either
We Are Live - Community Feedback
This has been talked about many times.
I've made a pole which no one has posted in, there are a few votes and comments.
Do you like the new forum features?
Wiki pages have been restored as of 7th December, I asked where is the link it should be on top of the main forum.
Forum Rules and Guidelines
This is a new forum layout with loads of bugs which have been reported in the new thread. There is no TDI Wiki at the moment or original similes. It doesn't show the car spec/location or signature properly either
We Are Live - Community Feedback
This has been talked about many times.
I've made a pole which no one has posted in, there are a few votes and comments.
Do you like the new forum features?
Wiki pages have been restored as of 7th December, I asked where is the link it should be on top of the main forum.
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Jetta cup edition front bumper removal and installation of thunderbunny body kit
Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forumThe thunderbunny body kit on the 2010 VW Jetta TDI cup edition is different enough to require another DIY article vs. the regular front bumper. For example, the license plate was removed just to check if there were any screws in that area like the regular bumper but there were not. The full...- 1
- 5K
-
chittychittybangbang · updated
-
Timing belt article BRM engine up
Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forumArticles include links to parts vendors so you can quickly compare pricing and kit components and differences between what the service manual shows and what may be on your car. There is also a bolt access hole that isn't mentioned in the service manual. Water pump change is in a separate...- 71
- 23K
-
chittychittybangbang · updated
-
Suttering/No acceleration/Tons of black smoke intermittently on take-off in 1st gear
Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forumI have a Jetta TDI Mark V 2005.5 BRM TDI with about 150k on it. Recently, I have noticed very intermittently when taking off in 1st year no matter how much you push down the accelerator, the RPM's do not increase. The car shakes and doesn't sound right and it pours black smoke out the exhaust...- 2
- 758
-
VCDS info needed for tuning CJAA actuator on BRM
Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forumThis is my first post ever in any forum except for my newbie post in the Intro section. So I am open to direction on etiquette and procedures. Ive been lurking in the background for a couple years tho so Im not completely oblivious. To the point: Ive searched extensively online and in this...- 2
- 880
-
2012 Audi A3 issues
Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forumHi everyone, Just bought a used 2012 Audi A3 TDI. When I did the VCDS scan, it showed that there's 4 fault and would like to get help on resolving them. Below are the screenshots of the scan. First fault: Second issue: Third issue: There's also a radio fault but it's not important...- 5
- 320
-
jaysol33 · updated
Join now to ask and comment!