VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
Just purchased Ross-Tech VCDS so still very much in newbie mode with it. Ran the first scan on my '05 Audi 2.0TDI A4 (B7) Avant and got the following error codes,

2 Faults Found:
01370 - Alarm triggered by Interior Monitoring
35-00 - -
01572 - Alarm triggered by Door Contact Switch; Passenger Side
35-00 - -

Bit puzzled as not aware of any problems with the alarm system and the Door Contact Switch is switching the interior/courtesy light on and off. I had a look at the code descriptors on the Ross-Tech website but still no wiser:dunno
 

·
Super Moderator
Joined
·
23,902 Posts
This is a common problem, just clear the codes and see if they come back. Sometimes there's an instant fault which goes away or the alarm goes off and it leaves a fault code. I had an older Audi and every year I'd get alarm codes or door switch codes but there was never a problem with the car.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #3
Many thanks. Cleared the DTCs and ran the car for a couple of days. Scanned again and no recurrence.:bowdown
 

·
Super Moderator
Joined
·
9,151 Posts
EOBD II Error Code: 01370

Fault Location:
Alarm triggered by Interior Monitoring

Possible Cause:
Anti-Theft Alarm triggered by Signal from Ultrasonic Sensor Control Module (J347).
Ultrasonic Sensor Control Module (J347) faulty.
Wiring/Connectors from/to Ultrasonic Sensor Control Module (J347) faulty.
False Alarm.

Possible Solutions:
Check/Clear Fault Codes.
Check Ultrasonic Sensor Control Module (J347).
Check Wiring/Connectors from/to Ultrasonic Sensor Control Module (J347).

Special Notes:
This fault code is only a note.

EOBD II Error Code: 01572

Fault Location:
Alarm triggered by Door Contact Switch; Passenger Side

Possible Cause:
Anti-Theft Alarm triggered by unauthorized opening of Passenger Door
Passenger Door Contact Switch (F3) faulty
Wiring/Connectors from/to Passenger Door Contact Switch (F3) faulty
False Alarm

Possible Solutions:
Check/Clear Fault Codes
Check Passenger Door Contact Switch (F3)
Check Wiring/Connectors from/to Passenger Door Contact Switch (F3)

Special Notes:
This fault code is only a note.


As taken from my http://www.myturbodiesel.com/forum/f9/free-eobd-ii-error-codes-software-2919/ ;)
 
1 - 4 of 4 Posts
Top