relay 109 question
Join the discussion
Recommended Reading
-
limp mode on 2,0 tdi 2013 transporter
General Diesel DiscussionI change engine , code the injector , i use a used engine with 40000km on. The problem i have now is that only get 2800 omdr.No fault code , no lamp on. I get a used turbo with the engine so i put on. i heard a wisled noise , if i take of the vacum on the solenoid the noise get away. But get...- 0
- 15
-
senjamann · updated
-
Poor cold start idle and acceleration problems
General Diesel DiscussionHello, guys! I've got a 1.9 TDI, 130HP (PD) and I've noticed some serious stuttering at cold start. It idles at around 980 RPM with revs bouncing, after a few kilometers, revs drop down to normal - 903 and it gets a little smoother but I still feel some of this stuttering upon acceleration, also...- 1
- 117
-
ShunASZ · updated
-
Free EOBD II Error Codes software
General Diesel DiscussionHi guys/gals. 5 years ago when I had my Golf GTD I printed out all 110 pages of data from AD for the Golf 2.0 TDI 2009 because that was the closest vehicle to mine. All the error codes printed out and it took an hour and a half 140 sheets, slow network printer. Some of you my know I make...- 156
- 672K
-
Keithuk · updated
-
2003 vw caravelle 2.5 tdi
General Diesel DiscussionHi. I been having issues with my van not having enough power up hills. I hsve the turbo plus the switches, diesel pump 3 times. I really don't no wat else to do. Sometimes is goes into a limp mode will driving and then u hot to pull over and switch off and on for it to clear. Plus it moves...- 1
- 251
-
Leon.Naidoo.2 · updated
-
2004 Beetle BEW hot start problem...
General Diesel Discussionhello.... I am having a hot start problem with my BEW.... my torsion value is dead on a 0*... I moved the cam timing to see it the value would change and it did so I moved back to 0* since the car otherwise runs well with 44.9 mpg..... I noticed that if I disconnect the CTS it starts perfectly...- 6
- 897
Join now to ask and comment!