VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hello. I'm new to VWs and diesels, but I've worked a lot on my Hyundai's and Saab. I'll be tackling an MK5 timing belt change in a week or two, so I'm here for the DIY. :D

Anyway, I've seen links to several sites for the 10mm triple square bit we need for the job, but no links to this site

http://www.tooltopia.com/vim-xzn110.aspx

I'm skeptical because it costs $2.93. Any thoughts? I don't want the bit snapping off when I'm trying to remove the bolts!
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #6 ·
Ha, ya...shipping usually defeats the advantage of a cheap online retailer. I have 3" and 6" extensions, so my concern was getting the shortest bit. Most of the bits I saw were quite long...and tools are usually better too short, right? It's easier to add an extension and squeeze too big of a tool into an engine bay. Thanks for the input!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top