my troubles
1 - 3 of 3 Posts
Joined
·
23,902 Posts
It's possible you got a batch of bad fuel. If there are no codes then keep driving until the codes show up again.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
AAZ Injection Timing Issues
VW Mk3 Jetta, Passat TDI and other/older dieselsI have an AAZ that's always been a little sluggish. I'd been driving it with the cold start lever constantly pulled out because it would stall otherwise. This lead me to believe the timing was too retarded. When I checked it, it was at 0.73mm, which is within the "check range" but I decided to...- 1
- 91
-
Starter Application for AAZ with 020 Trans
VW Mk3 Jetta, Passat TDI and other/older dieselsI have 1995 Cabrio with an AAZ swapped into it. Recently, I've been having starter troubles and am looking into some options as far as new starters go. I'm not sure exactly what starter is in there currently, but I did some reading on forums and such and it looks like a lot of people are saying...- 1
- 162
-
2005 VW Pass bal shaft del kit issue
VW Mk3 Jetta, Passat TDI and other/older dieselsI have a 2005 VW Passat w/ the 2.0 TDI BHW. Wife was driving car and the low oil press. light came on, so she drove 5 min to get home. I installed a new oil press. sensor and a new oil filter. Then ran the engine a few mins and concluded: no oil pressure. I read online about the balance shaft...- 4
- 315
-
MAF Air sensor, actual is higher than specified ?
VW Mk3 Jetta, Passat TDI and other/older dieselsHello, can someone told me, is my MAF sensor bad? Car is Audi 80 B4, 1.9 tdi 66kw, 1z engine, and works normaly and no problems with speed or with nothing. But some days ago, the car shut down while driving, and after that works normally like before. But today again, the car shut down while...- 1
- 396
-
Alik · updated
-
Passat AFN 110 weird issue
VW Mk3 Jetta, Passat TDI and other/older dieselshaving sorted out a duff fuel temp sensor later in the day car starts to rock at tickover so removed oil cap and i have vcds lite unregistered in measuring blocks group 4 i read 882 rpm 1.3 btdc 0.9btdc 1176rpm 0.4 atdc 0.4 atdc do u think timing is out or are piston rings shot i...- 3
- 625
Join now to ask and comment!