VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum banner
Cancel

how to adjust vnt rod to spec

6984 Views 4 Replies 4 Participants Last post by  pdq, 
C
Hi how do you adjust the rod to spec how far out should it be?
thanks
Reply
Save
Like
1 - 1 of 5 Posts
P
I just went through this dance on an 03 Jetta, I did measure the actuator rod for referance. It was 88mm from base of the vacuum can to the center of the hole, I eventually ended up at 92mm to get this particular one to work.

that is at least a starting point if you have nothing to go on.
Reply
Save
Like
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum
A forum community dedicated to Audi, Volkswagen, Porsche, and all turbo diesel owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, TDI, maintenance, and more!
Full Forum Listing
Explore Our Forums
VW Mk4 Jetta, Golf, New Beetle, Passat TDI forum Mk5 VW Jetta, Sportwagen, and Audi A3 TDI forum New TDI forum member introductions VW Mk6 Golf, Jetta, Beetle, Sportwagen TDI forum General Diesel Discussion
Top