VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum banner

hello everyone new member

875 Views 2 Replies 3 Participants Last post by  ZoomALH
hello

My car is a Golf mk4 tdi 115 @ 145 by ATH HEINZ

i have remove the turbo and clean the vanes,
how to adjust the vnt rod now ?

i have smal low end , and good power from +- 2500 rpm

new Mass air flow sensor ..

i speek litle english ^^ french ...

thanks



by auto tune heinz http://www.autotuneheinz.be/index.php#//start//nl
1 - 3 of 3 Posts
Did you test it before replacing it?

The best thing to do is to test it to make sure the rod motion is at the same vacuum range. However, we only had the 90 horsepower engine, the 115 hp engine may be a little different. The easy thing to do is to make sure the rod is the same length as before. See this article for pictures: http://www.myturbodiesel.com/1000q/a4/VNT-wastegate-adjust.htm
i speek litle english ^^ french ...

thanks
No problem, you write fine. I can't tell how you speak though :p
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top