VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum banner

Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1 (Edited by Moderator)
sorry this is sold

I have a good running 1.9 liter TDI engine pulled from my 2006 Jetta with 78000K. My wife ran over something in the road and put a small crack in one of the engine block mounting positions. The insurance company replaced the entire engine and i was able to keep the original engine. The crack can be welded. It isnt in the block itself its only on the mounting position where the bolt from the engine mount screws into. The engine comes complete with the turbo intack. The dealership just yanked the old motor and dropped in the new. The engine ran like a top right up till the day it was pulled out. I am asking $ 1500.00 and the buyer arranges shipping.
 

·
Registered
Joined
·
226 Posts
FYI, if it's the passenger side engine mount area you can use the ALH engine mount with the van gogh bracket to repair the broken tab. It uses a different hole and the bracket will fix the tab in the back that likes ot break.
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top