Does anyone have some suggestions on an easy way to wire a power cord to the fuse panel for a Passport radar detector? I have used this same cord in my previous cars (Audis) and have always found a vacant spot on the panel that provides switched 12V power that I can tap into. I usually connect a spade terminal into the fuse panel and secure the common to a nearby screw. The cord has an inline fuse in it. Can't figure it out on my new 2010 JSW.
1 - 2 of 2 Posts
I found an empty fuse slot that had power only when the ignition was switched on and was able to use that. Because it was in to top row of the fusebox and used the smaller fuses, I had to cut down the spade terminal almost in half so that it would fit into the connection slot. I'm all set now though and everything is working fine.
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
VW TDI forum, Audi, Porsche, and Chevy Cruze Diesel forum
A forum community dedicated to Audi, Volkswagen, Porsche, and all turbo diesel owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, TDI, maintenance, and more!
Full Forum Listing
Join now to ask and comment!
